Seat Cushion - Front, 60 Percent: Assembly

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Position the cushion trim cover to the foam pad and install the rows of hog rings.

Fig 1: Locating Seat Cushion Trim Cover & Hog Rings
Courtesy of FORD MOTOR CO.
Install the foam pad and trim cover to the seat cushion frame.
Route the seat backrest latch release cable through the cushion frame and install the pin-type retainer.

Fig 2: Locating Seat Back Latch Release Cable Retainer
Courtesy of FORD MOTOR CO.
Fasten the trim cover J-clips.

Fig 3: Locating Trim Cover J-Clips
Courtesy of FORD MOTOR CO.
Install the seat track position sensor and 2 screws to the seat track.
Install the seat track. For additional information, refer to Seat Track - 60 Percent in this article.
Install the backrest assembly. For additional information, refer to Seat Backrest - Front, 60 Percent in this article.
Install the armrest. For additional information, refer to Seat Armrest - 60 Percent in this article.
Install the affected seat. For additional information, refer to Seat - Front in this article.