All seats
- Install the backrest foam pad to the backrest frame.
- Position the backrest trim cover to the backrest and install the hog rings.
- Roll the trim cover down the backrest and fasten the hook-and-loop strips.
- Fasten the backrest J-clip.
- Install the affected seat backrest. For additional information, refer to Seat Backrest - Front, Bucket and 40 Percent in this article.
- Install the seat. If a passenger seat has been serviced, do not prove out the SRS at this time. For additional information, refer to front seat Seat - Front in this article.
- Prove out the SRS as follows:
Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag warning indicator with the air bag modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn off. If an SRS fault is present, the air bag warning indicator will:
- fail to light.
- remain lit continuously.
- flash at a 5Hz rate (RCM not configured).
The air bag warning indicator may not illuminate until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position. This is the time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be diagnosed and repaired.
Clear all continuous RCM and occupant classification system module (OCSM) DTCs using a scan tool.