Seat Backrest - Front, 60 Percent: Assembly

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Slide the backrest frame into the backrest foam pad.

Fig 1: Sliding Backrest Frame Into Backrest Foam Pad
Courtesy of FORD MOTOR CO.
Install the lower end of the backrest foam pad on the backrest frame.

Fig 2: Installing Lower End Of Backrest Foam Pad On Backrest Frame
Courtesy of FORD MOTOR CO.
Install the backrest trim cover and install all of the hog rings.

Fig 3: Locating Hog Rings & Backrest Trim Cover
Courtesy of FORD MOTOR CO.
Pull the backrest trim cover down and secure the hook-and-loop strips to the backrest foam pad.

Fig 4: Pulling Backrest Trim Cover Down
Courtesy of FORD MOTOR CO.
Attach the backrest J-clip.

Fig 5: Locating Backrest J-Clip
Courtesy of FORD MOTOR CO.
Install the 60 percent seat backrest assembly. For additional information, refer to Seat Backrest - Front, 60 Percent in this article.
Install the 60 percent armrest. For additional information, refer to Seat Armrest - 60 Percent in this article.
Install the affected seat. For additional information, refer to Seat - Front in this article.