Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Make sure the headlamp switch and the ignition switch are in the OFF position.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
- Remove the 2 nuts, the bolt, and the fog lamp.
- Disconnect the electrical connector.
- To install, tighten to 5 Nm (44 lb-in).
- To install, reverse the removal procedure.