Turn Signal/Hazard Lamps

The front turn signal lamps are located within the headlamp assemblies. When the multifunction switch is placed in the LH or RH TURN position, the multifunction switch routes voltage to the LH or RH turn signal lamps. The indicator flasher relay then cycles the voltage on and off approximately 80 times per minute. If a front or rear turn bulb is inoperative, the indicator flasher relay cycles the voltage on and off approximately 160 times per minute.

The hazard switch is integral to the multifunction switch. When the hazard switch is engaged, the indicator flasher relay supplies voltage to all the turn lamps. The indicator flasher relay cycles the voltage on and off approximately 80 times per minute.