All bumpers
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the 4 rear bumper beam-to-inner bumper bracket nuts.
- To install, tighten to 115 N.m (85 lb-ft).
- Remove the 2 retainer and bolt assemblies from the rear bumper beam-to-inner bumper brackets.
NOTE:
This procedure may require an assistant.
- Remove the rear bumper beam.
- Disconnect the electrical connectors.
- To install, reverse the removal procedure.