Fender Splash Shield

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The RH front fender splash shield electrical connector locators must be disconnected from the splash shield prior to splash shield removal. The LH front fender splash shield vacuum lines must be disconnected from the vacuum storage reservoir prior to splash shield removal.

Fig 1: Locating Front Fender Splash Shield Scrivets

Courtesy of FORD MOTOR CO.

Remove the 3 scrivets from inside the front fender splash shield.
Remove the 2 bolts from the lower front of the front fender splash shield.

Fig 2: Locating Front Fender Splash Shield Bolts
Courtesy of FORD MOTOR CO.

NOTE: The LH front fender splash shield is equipped with a bolt and a nut. The RH front fender splash shield is equipped with 2 bolts.

Fig 3: Locating Front Fender Splash Shield Nut & Bolt

Courtesy of FORD MOTOR CO.

Remove the bolt and the nut from the front fender splash shield.
Remove the 5 pushpins from the front fender splash shield-to-inner splash shield.

Fig 4: Locating Front Fender Splash Shield-To-Inner Splash Shield Pushpins
Courtesy of FORD MOTOR CO.
- Remove the inner splash shield.
Remove the scrivet from the lower rear splash shield.

Fig 5: Locating Lower Rear Splash Shield Scrivet
Courtesy of FORD MOTOR CO.
Remove the front fender splash shield.
To install, reverse the removal procedure.