Throttle Body: Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Position the TB gasket, the TB and install the 4 bolts in the sequence shown.
- Inspect the throttle body gasket and install a new gasket as necessary.
- Tighten to 10 Nm (89 lb-in).
- Connect the TP sensor electrical connector.
- Connect the accelerator cable and the speed control cable (if equipped).
- Install the air cleaner outlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.