Lean Correction - Rear

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: A side to side lean may be adjusted by 6 mm (0.25 in). This is accomplished by placing a shim (D7TZ-5742-A) between the rear spring and the axle on the low side of the vehicle.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Using a suitable jack, support the rear axle.
Remove and discard the 4 rear nuts and U-bolts.

Fig 1: Locating Nuts & U-Bolts
Courtesy of FORD MOTOR CO.
- Remove the spring plate.
- To install, tighten to 115 Nm (85 lb-ft).
Using the jack, lower the rear axle approximately 13 mm (0.51 in).

NOTE: Make sure that the spring locator bolt is centered in the spacer hole.

NOTE: On vehicles equipped with a spring spacer block, place the shim between the rear spring and the axle spacer.

Install the spacer (D7TZ-5742-A) between the spring and the axle.