Window Glass - Rear: Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Install the rear window glass.
- Apply foam core butyl to the window. Overlap the foam core butyl by 25 mm (1 in) at the bottom middle of the rear window glass.
- Carefully install the rear window glass into the body opening.
- Install the rear window glass nuts.
- Tighten to 2 Nm (18 lb-in).
- Test the rear window glass for water leaks.
- Install the headliner. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
- Install the rear window glass garnish moulding.
NOTE:
Remove as much as possible of the foam core butyl from the body and rear window glass prior to installation.