Clutch Slave Cylinder: Removal
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the transmission. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION article.
- Remove the clutch slave cylinder.
- Remove the clutch slave cylinder bolts.
- Remove the clutch slave cylinder.
- Inspect the clutch slave cylinder for the following:
- Worn or damaged boot.
- Leaking fluid.
- Worn or damaged bearing.
- Inspect the clutch release bearing as follows:
- Rotate the outer race while applying pressure. If the bearing rotation is rough, install a new clutch slave cylinder.
- Inspect for wear or damage.
NOTE:
Inspect the clutch housing for traces of fluid. If brake fluid is visible, install a new clutch slave cylinder.