Clutch Pedal: Removal

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Using a screwdriver, disconnect the clutch master cylinder rod from the clutch pedal pin.

Fig 1: Locating Clutch Master Cylinder Rod
Courtesy of FORD MOTOR CO.
Remove the LH cowl side trim panel.
Remove the parking brake release bolts.

Fig 2: Locating Parking Brake Release Bolts
Courtesy of FORD MOTOR CO.
- To install, tighten to 2.5 Nm (22 lb-in).
Remove the parking brake control bolts, then position the parking brake control aside.

Fig 3: Locating Parking Brake Control Bolts
Courtesy of FORD MOTOR CO.
- To install, tighten to 20 Nm (15 lb-ft).
Remove the retaining ring, then slide the clutch pedal from the clutch and brake pedal support.