4.0L SOHC engine

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Transmission To Engine Bolts

Courtesy of FORD MOTOR CO.

NOTE: Align the flexplate to the converter marks made at removal.

Install the transmission-to-engine screws.
1. Install 2 M10 x 40 mm (1.57 in) screws.
2. Install 4 M10 x 50 mm (1.96 in) screws.
3. Install 2 M10 x 75 mm (2.95 in) screws.
- Tighten to 55 Nm (41 lb-ft).