Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
- If equipped, loosen the nut and position the heat shield aside.
- If equipped, position the servo heat shield over the servos and clip it to the pan rail.
- Tighten to 10 Nm (89 lb-in).
NOTE:
If equipped, the transmission servo heat shield needs to be unclipped from the fluid pan rail and positioned aside for fluid pan removal.