Extension Housing Seal and Bushing: Removal

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .

Fig 1: Marking Driveshaft Flange And Rear Pinion Flange

Courtesy of FORD MOTOR CO.

NOTE: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they can be installed in their original alignment.

Mark the rear driveshaft.

Fig 2: Locating Driveshaft Flange Bolts

Courtesy of FORD MOTOR CO.

Remove the 4 rear driveshaft bolts.

Fig 3: Disconnecting Driveshaft Flange Yoke From Pinion Flange

Courtesy of FORD MOTOR CO.

NOTE: Do not use a hammer.

Remove the rear driveshaft from the flange using a pry bar.

Fig 4: Identifying Special Tools (100-001, 307-309)

Courtesy of FORD MOTOR CO.

Using the special tools, remove the extension housing seal.

Fig 5: Identifying Special Tools (308-070)

Courtesy of FORD MOTOR CO.

CAUTION: Use the extension housing bushing remover carefully so that the seal area is not damaged.

Using the special tool, remove the extension housing bushing.