Transmission Fluid Drain and Refill - Vehicles Not Equipped With Torque Converter Drain Plug: Refill
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Install the transmission fluid pan.
- Position a new transmission fluid pan gasket on the transmission fluid pan.
- Install and align the transmission fluid pan.
- Loosely install the transmission fluid pan screws.
- Tighten the transmission fluid pan screws in a crisscross sequence.
- Tighten to 16 Nm (12 lb-ft).
- If equipped, position the servo heat shield over the servos and clip it to the pan rail.
- Tighten to 10 Nm (89 lb-in).
- Lower the vehicle. For additional information, refer to JACKING AND LIFTING .
- With the engine running and the transmission at normal operating temperature 66-77°C (150-170°F), check and adjust the transmission fluid level and check for any leaks. If fluid is needed, add fluid in increments of 0.24 liter (0.5 pint) until the correct level is achieved (fluid should be in the cross-hatched area of the fluid level indicator).
- Apply the park brake and start the engine.
- Move the range selector lever through all the gears.
- Check the transmission fluid level.
NOTE:
When filling a dry transmission and converter, start with a minimum of 3.7 liters (4 quarts).