Reverse Brake Drum: Assembly

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Roller Bearing With Lip Facing Up Toward Low/Reverse One-Way Clutch

Courtesy of FORD MOTOR CO.

Install the roller bearing with the lip facing up toward the low/reverse one-way clutch.

Fig 2: Identifying Special Tool (307-395)

Courtesy of FORD MOTOR CO.

Install the special tool.

Fig 3: Installing Low/Reverse One-Way Clutch With Tabs Facing Down Toward Roller Bearing Using Special Tool (307-395)

Courtesy of FORD MOTOR CO.

Install the low/reverse one-way clutch with the tabs facing down toward the roller bearing.

Fig 4: Identifying Special Tools (307-395, 307-396)

Courtesy of FORD MOTOR CO.

Using the special tools, install the one-way clutch by pressing down on the tool to seat the bearing.

Fig 5: Identifying Reverse Clutch Drum

Courtesy of FORD MOTOR CO.

Inspect the reverse clutch drum to see if the low/reverse one-way clutch is seated correctly.