Output Shaft Ring Gear and Hub Shaft Assembly: Disassembly

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Output Shaft Ring Gear & Hub Shaft Assembly

Courtesy of FORD MOTOR CO.

Item	Part Number	Description
1	7A153	Shaft ring gear
2	7D164	Output shaft hub
3	E860122	Retaining ring
4	7M150	Needle bearing race assembly (No. 10A)
5	7M150	Needle bearing (No. 10B)

Inspect the output shaft ring gear, output shaft hub, needle bearing (No. 10B) and needle bearing race (No. 10A) assembly for damage. If service is required, use the following procedure.

Fig 2: Identifying No. 10B Needle Bearing

Courtesy of FORD MOTOR CO.

Remove the No. 10B needle bearing.

Fig 3: Identifying No. 10A Needle Bearing Race Assembly

Courtesy of FORD MOTOR CO.

Remove the No. 10A needle bearing race assembly.

Fig 4: Identifying Output Shaft Hub From Output Shaft Ring Gear

Courtesy of FORD MOTOR CO.

Remove the output shaft hub from the output shaft ring gear.
1. Remove the retaining ring.
2. Remove the output shaft hub.