Output Shaft Ring Gear and Hub Shaft Assembly: Assembly

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Output Shaft Hub Onto Output Shaft Ring Gear

Courtesy of FORD MOTOR CO.

Install the output shaft hub onto the output shaft ring gear.
1. Install the output shaft hub.
2. Install the retaining ring.

Fig 2: Identifying No. 10A Needle Bearing Race Assembly

Courtesy of FORD MOTOR CO.

Install the No. 10A needle bearing race assembly.
- Snap the needle bearing race assembly onto the output shaft hub.

Fig 3: Identifying No. 10B Needle Bearing

Courtesy of FORD MOTOR CO.

NOTE: Use petroleum jelly to hold the needle bearing to the output shaft ring gear and output shaft hub.

Install the No. 10B needle bearing onto output shaft ring gear and output shaft hub.