Camshaft End Play - Push Rod Engines
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| Dial Indicator Gauge with Holding Fixture | 100-002 (TOOL-4201-C) or equivalent |
NOTE:
Refer to the appropriate Section 303-01 for the specification.
- Remove the hydraulic lash adjusters. Refer to the appropriate Engine article for the procedure.
- Use a Dial Indicator Gauge with Holding Fixture to measure camshaft end play.
- Position the camshaft to the rear of the cylinder block.
- Zero the indicator.
- Move the camshaft to the front of the cylinder block. Note and record the camshaft end play.