Vehicles with 3.0L engine and 4.0L engine
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Position the exhaust Y-pipe assembly to the exhaust manifold and loosely tighten the exhaust Y-pipe assembly-to-exhaust manifold nuts to stiffen the joint.
- Tighten to 8 Nm (71 lb-in).
NOTE:
RH side shown, LH side similar.
NOTE:
3.0L shown, 4.0L similar.
- Tighten the exhaust Y-pipe assembly-to-exhaust manifold nuts.
- Tighten to 40 Nm (30 lb-ft).
NOTE:
RH side shown, LH side similar.
NOTE:
3.0L shown, 4.0L similar.
- Tighten the RH side of the exhaust Y-pipe-to-muffler and tailpipe assembly bolts.
- Tighten to 40 Nm (30 lb-ft).