Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Using the special tools, remove the audio unit.
- Disconnect the antenna cable and electrical connectors.
Remove the center instrument panel finish panel.

Fig 1: Identifying Center Instrument Panel Finish Panel Screws
Courtesy of FORD MOTOR CO.
- Remove the 2 screws.
- Disengage the spring clips and remove the instrument panel finish panel.
- Disconnect the electrical connectors.
Release the 8 clips and remove the center registers.

Fig 2: Locating Center Instrument Panel Register & Clips
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.