Peanut Fitting
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | - | Female block |
| 2 | W701890-S426 | Stud (part of female block) |
| 3 | - | Male block |
| 4 | W520413-S301 | Nut |
| 5 | 19E889 | O-ring seal |
When disconnecting or connecting peanut fittings, observe the following.
- The male and female blocks of the peanut fitting are retained with a nut.
- Support the female fitting with a wrench to prevent twisting of the tubes.
- An O-ring seal is installed around the tube on the male block.
- When correctly assembled, the male and female fittings should be flush.
- Use only the O-ring seal listed in the Ford Master Parts Catalog.