Crankshaft Position (CKP) Sensor - 2.3L: Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Whenever the crankshaft position (CKP) sensor is removed, a new one must be installed using the alignment tool supplied with the new part.

Position the CKP sensor and loosely install the 2 bolts.

NOTE: The CKP sensor alignment tool is supplied with the new sensor and is not available separately.

Fig 1: Locating CKP Sensor Alignment Tool And Bolts

Courtesy of FORD MOTOR CO.

Adjust the CKP sensor with the alignment tool and tighten the 2 bolts.
- Tighten to 7 Nm (62 lb-in).
Connect the CKP sensor electrical connector.
Remove the M6 bolt.

Fig 2: Installing Bolt Through Crankshaft Pulley And Thread It Into Front Cover
Courtesy of FORD MOTOR CO.
Remove the special tool.

Fig 3: Identifying Special Tool
Courtesy of FORD MOTOR CO.
Install the engine plug bolt.

Fig 4: Locating Engine Plug Bolt
Courtesy of FORD MOTOR CO.
- Tighten to 20 Nm (15 lb-ft).