LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 886 (Engine Cooling System) >> General Procedures >> Cooling System Draining, Filling and Bleeding - 2.3L >> Filling and Bleeding without RADKITPLUS >> Filling and bleeding procedure for use with partial drain

Filling and bleeding procedure for use with partial drain

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure the radiator draincock is completely closed.
  2. Fill the system through the degas bottle cap to 15 mm (0.590 in) above the maximum fill level.
  3. Install the degas bottle cap.
    4. WARNING: Do not stand in line with or near the engine cooling fan blade when revving the engine. A damaged fan can separate during operation. Failure to follow this instruction may result in serious personal injury.
  4. Start the engine and hold at 2,500 RPM engine speed for approximately 8 minutes until the thermostat opens.
  5. Maintain 2,500 RPM engine speed for an additional 3 minutes.
  6. Increase engine speed to 4,000 RPM and hold for 5 seconds.
  7. Return engine speed to 2,500 RPM and hold for an additional 3 minutes.
  8. Stop the engine and check for leaks.
scientia non olet · About LEMON Manuals