Pinpoint Test B: Outer Edge/Shoulder Wear

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

B1 MEASURE THE TREAD DEPTH
- Using a tread depth gauge or similar tool, measure the outside edge/shoulder tread depth.
- Is the tread depth greater than 1.58 mm (2/32 in)?
1. YES : ROTATE the wheel and tire assemblies.
  CHECK and ADJUST the toe to nominal -0.15 degree (toe-out). CHECK and ADJUST caster and camber to nominal. REFER to SUSPENSION SYSTEM - GENERAL INFORMATION article.
2. NO : INSTALL a new tire(s).
  CHECK and ADJUST the toe to nominal. CHECK and ADJUST caster and camber to nominal. REFER to SUSPENSION SYSTEM - GENERAL INFORMATION article.