LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 880 (Power Steering System) >> Removal And Installation >> Power Steering Pump Pulley - 3.0L, 4.0L >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: 4.0L engine shown, 3.0L engine similar.
  1. Loosen the power steering pump pulley bolts.
    2. NOTE: For additional information on accessory drive belt routing, refer to ACCESSORY DRIVE article.
  2. Rotate the accessory drive belt tensioner counterclockwise and position the accessory drive belt aside.
  3. Remove the 3 bolts and the power steering pump pulley.
    • To install, tighten to 25 Nm (18 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals