Power Steering Pump Pulley - 2.3L: Removal

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Remove the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
Rotate the accessory drive belt tensioner counterclockwise and position the accessory drive belt aside.

Fig 1: Locating Accessory Drive Belt Tensioner
Courtesy of FORD MOTOR CO.

CAUTION: Replacement of the power steering pump pulley is necessary after being removed and installed 2 times.

Fig 2: Removing Power Steering Pump Pulley Using Special Tool

Courtesy of FORD MOTOR CO.

Using the special tool, remove the power steering pump pulley.
- Inspect the pulley for paint marks in the web area near the hub. If there are 2 paint marks, discard the pulley. If there is no paint mark or 1 paint mark, use a paint pencil to mark the web area of the pulley near the hub.