LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 875 (Engine - 4.0L (SOHC)) >> Removal >> Engine >> Removal >> Vehicles equipped with an automatic transmission

Vehicles equipped with an automatic transmission

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission level indicator tube nut.
    Fig 1: Locating Transmission Level Indicator Tube Nut
    GF0009400Courtesy of FORD MOTOR CO.


  1. Disconnect the RH catalyst monitor sensor electrical connector, remove the nut and route the bracket and wiring harness over the transmission.
    Fig 1: Locating RH Catalyst Monitor Sensor Electrical Connector
    GF0009402Courtesy of FORD MOTOR CO.
  2. Disconnect the LH catalyst monitor sensor and the transmission electrical connectors. Detach the wiring harness retainers.
    Fig 2: Locating LH Catalyst Monitor Sensor & Transmission Electrical Connectors
    GF0009403Courtesy of FORD MOTOR CO.
  3. Remove the bolt and position the transmission cooling tube bracket aside.
    Fig 3: Locating Transmission Cooling Tube Bracket Aside
    GF0009404Courtesy of FORD MOTOR CO.
  4. Remove the 4 torque converter nuts.
    Fig 4: Locating Torque Converter Nuts
    GF0009405Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals