LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 875 (Engine - 4.0L (SOHC)) >> In-Vehicle Servicing >> Timing Drive Components - Hydraulic Chain Tensioner, RH >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the hydraulic chain tensioner.
    • To install, tighten to 44 Nm (32 lb-ft).
    2. NOTE: Lubricate the new O-ring seal with clean engine oil.
  2. Remove and discard the O-ring seal.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals