LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 875 (Engine - 4.0L (SOHC)) >> In-Vehicle Servicing >> Timing Drive Components - Hydraulic Chain Tensioner, LH >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. For additional information, refer to Intake Manifold  in this article.
  2. Remove the thermostat housing. For additional information, refer to ENGINE COOLING article.
  3. Remove the hydraulic chain tensioner.
    • To install, tighten to 44 Nm (32 lb-ft).
    4. NOTE: Lubricate the new O-ring seal with clean engine oil.
  4. Remove and discard the O-ring seal.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals