In-Vehicle Servicing: Flywheel: Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Special bolts are used for flywheel installation. Do not use standard bolts.

Fig 1: Identifying Flywheel Bolts Tightening Sequence

Courtesy of FORD MOTOR CO.

Position the flywheel and install the bolts. Tighten the bolts in the sequence shown in 3 stages.
- Stage 1: Tighten to 13 Nm (10 lb-ft).
- Stage 2: Tighten to 50 Nm (37 lb-ft).
- Stage 3: Tighten an additional 90 degrees.
Install the clutch. For additional information, refer to CLUTCH article.