Exhaust Manifold - RH: Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Clean and inspect the RH exhaust manifold. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
- Install 6 new RH exhaust manifold studs.
- Tighten to 12 Nm (9 lb-ft).
- Position a new gasket and the RH exhaust manifold and install 6 new nuts.
- Tighten to 22 Nm (16 lb-ft).
- Position the dual converter Y-pipe and install the nuts.
- To install, tighten to 40 Nm (30 lb-ft).