4WD vehicles

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Any time bolts, washers, spacers or nuts are loosened in the front axle housing for any reason, install new components to prevent damage.

Fig 1: Raising Axle Housing Into Installed Position

Courtesy of FORD MOTOR CO.

Raise the front axle housing into place and install new bolts and nuts.
- Tighten to 66 Nm (49 lb-ft).
- Remove the jack.
Install the dual converter Y-pipe. For additional information, refer to EXHAUST SYSTEM article.