LH side

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Remove the LH hydraulic chain tensioner. For additional information, refer to Timing Drive Components - Hydraulic Chain Tensioner, LH in this article.
Install the special tools on the front of the LH camshaft and tighten the 2 top clamp bolts to 10 Nm (89 lb-in).

Fig 1: Identifying Special Holding Tool
Courtesy of FORD MOTOR CO.
Loosen the bolt.

Fig 2: Locating Bolt
Courtesy of FORD MOTOR CO.
Remove the bolt and position the camshaft sprocket aside.

Fig 3: Locating Camshaft Sprocket Bolt
Courtesy of FORD MOTOR CO.