Both sides

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Install the camshaft.

NOTE: The camshaft bearing caps must be installed in their original positions.

NOTE: After installing the bolts, check the camshaft for free rotation.

Fig 1: Identifying Camshaft Bearing Cap Bolts Tightening Sequence

Courtesy of FORD MOTOR CO.

Install the camshaft bearing caps and the bolts.
- Tighten the bolts in the sequence shown in 2 stages.
  - Stage 1: Tighten to 6 Nm (53 lb-in).
  - Stage 2: Tighten to 16 Nm (12 lb-ft).

CAUTION: The camshafts must be re-timed or engine damage may occur.

Re-time both camshafts. For additional information, refer to Camshaft Timing in this article.