Disassembly And Assembly Of Subassemblies: Piston: Disassembly

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The connecting rod bolts and nuts cannot be reused.

NOTE: Mark the position of the parts, so they can be installed in their original positions.

Remove the connecting rod bearings from the connecting rod and cap.
Remove the piston rings from the piston.
Using the special tool, press the piston pin out of the connecting rod and piston assembly.

Fig 1: Identifying Special Tool (303-S024)
Courtesy of FORD MOTOR CO.