LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 874 (Engine - 3.0L (2V)) >> Installation >> Engine >> Vehicles equipped with a manual transmission

Vehicles equipped with a manual transmission

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the transmission and the LH catalyst monitor sensor electrical connectors and attach the wiring harness retainers.
    Fig 1: Locating LH Catalyst Monitor Sensor Electrical Connectors
    GF0009213Courtesy of FORD MOTOR CO.
  2. Connect the transmission electrical connector and attach the wiring harness retainer.
    Fig 2: Locating Transmission Electrical Connector & Wiring Harness Retainer
    GF0009212Courtesy of FORD MOTOR CO.
  3. Route the wiring harness over the transmission and position the wiring harness bracket. Install the nut and connect the RH catalyst monitor sensor electrical connector.
    Fig 3: Locating Nut & RH Catalyst Monitor Sensor Electrical Connector
    GF0009211Courtesy of FORD MOTOR CO.
    • Tighten to 30 Nm (22 lb-ft).
scientia non olet · About LEMON Manuals