Valve Cover - LH: Removal
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the upper intake manifold. For additional information, refer to Upper Intake Manifold in this article.
- Disconnect the LH spark plug wire holders.
- Disconnect the engine wiring harness from the valve cover studs.
- Disconnect the PCV valve electrical connector.
- Remove the 3 bolts and the 5 stud bolts.
- Remove the valve cover.
- Remove and discard the valve cover gasket.
- Clean the LH valve cover gasket mating surfaces.
NOTE:
To prevent stretching the valve cover gasket, loosen silicone gasket and sealant from the cylinder head by sliding a flat knife between the valve cover gasket and cylinder head.
CAUTION:
Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges, which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
NOTE:
To clean the sealing area, use silicone gasket remover and metal surface prep. Observe all warnings and cautions and follow all application directions contained on the packaging of the silicone gasket remover and metal surface prep.