LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 874 (Engine - 3.0L (2V)) >> In-Vehicle Servicing >> Rocker Arm >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: During engine repair procedures, cleanliness is extremely important. Any foreign material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
  1. Remove the valve cover. For additional information, refer to Valve Cover - LH  and/or Valve Cover - RH  in this article.
    2. NOTE: Identify and mark the location of each rocker arm. Each rocker arm must be installed in the original location.
  2. Remove the bolts and the rocker arms and fulcrums.
    • To install, tighten to 32 Nm (24 lb-ft).
  3. To install, reverse the removal procedure.
    • Lubricate the rocker arms and fulcrums with clean engine oil.
scientia non olet · About LEMON Manuals