LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 874 (Engine - 3.0L (2V)) >> In-Vehicle Servicing >> Push Rod >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: During engine repair procedures, cleanliness is extremely important. Any foreign material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
  1. Remove the rocker arms. For additional information, refer to Valve Train Components - Exploded View  or Rocker Arm  in this article.
    2. NOTE: Identify and mark the location of each push rod. Each push rod must be installed in the original location.
  2. Remove the push rods.
  3. To install, reverse the removal procedure.
    • Lubricate the push rods with clean engine oil.
scientia non olet · About LEMON Manuals