LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 874 (Engine - 3.0L (2V)) >> In-Vehicle Servicing >> Oil Pressure Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Disconnect the oil pressure sensor electrical connector from the oil pressure sensor.
  3. Remove the oil pressure sensor.
    • To install, tighten to 20 Nm (15 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals