LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 874 (Engine - 3.0L (2V)) >> In-Vehicle Servicing >> Oil Pan - Rear Wheel Drive (RWD) >> Removal >> Vehicles equipped with coil springs

Vehicles equipped with coil springs

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner outlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
  2. Remove the nuts from the engine mounts.
    Fig 1: Locating Engine Mount Nuts
    GF0009157Courtesy of FORD MOTOR CO.
  3. Install the Lifting Eyes, the Three-Bar Engine Support and raise the engine 43 mm (1.72 in).
  4. Install blocks between the engine mounts and the support brackets.
scientia non olet · About LEMON Manuals