Exhaust Manifold - RH: Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Install a new exhaust manifold gasket, bolts and stud bolts.

Install the exhaust manifold gasket, exhaust manifold, bolts and stud bolts.
- Tighten in the sequence shown in 2 stages.
  
  Fig 1: Identifying Tightening Sequence Of Exhaust Manifold Bolts
  Courtesy of FORD MOTOR CO.
- Stage 1: Tighten to 10 Nm (89 lb-in).
- Stage 2: Tighten to 23 Nm (17 lb-ft).
Install the exhaust flange nuts.