LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 874 (Engine - 3.0L (2V)) >> In-Vehicle Servicing >> Engine Support Insulators - RH >> Removal >> Four wheel drive (4WD) vehicles

Four wheel drive (4WD) vehicles

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the RH front halfshaft. For additional information, refer to FRONT DRIVE HALFSHAFTS article.
  2. Remove the engine support insulator nut.
    Fig 1: Locating Engine Support Insulator Nut
    GF0009180Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals