LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 874 (Engine - 3.0L (2V)) >> In-Vehicle Servicing >> Engine Support Insulators - RH >> Removal >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  3. Remove the hood.
  4. Remove the fan blade. For additional information, refer to ENGINE COOLING article.
  5. Attach the Lifting Eyes.
  6. Remove the engine support insulator nuts.
    Fig 1: Locating Engine Support Insulator Nuts
    GF0009179Courtesy of FORD MOTOR CO.
  7. Raise the engine and support with a Three-Bar Engine Support Kit.


  1. Remove the engine support insulator.
scientia non olet · About LEMON Manuals