LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 874 (Engine - 3.0L (2V)) >> In-Vehicle Servicing >> Crankshaft Pulley >> Removal

Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Remove the air cleaner outlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
  3. Remove the fan blade and the fan shroud. For additional information, refer to ENGINE COOLING article.
  4. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE article.
  5. Remove the 4 bolts and the crankshaft pulley.
  6. Remove the crankshaft bolt and the washer.
  7. Using the special tool, remove the crankshaft damper.
    Fig 1: Removing Crankshaft Damper Using Special Tool
    GF0009115Courtesy of FORD MOTOR CO.
  8. Remove the crankshaft key, if necessary.
    Fig 2: Locating Crankshaft Key
    GF0009116Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals