Crankshaft Pulley: Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Apply a drop of silicone gasket and sealant, securing crankshaft key in position.

Fig 1: Locating Crankshaft Key

Courtesy of FORD MOTOR CO.

If removed, install the crankshaft key.
Using the special tool, install the crankshaft damper.

Fig 2: Installing Crankshaft Damper Using Special Tool (303-175)
Courtesy of FORD MOTOR CO.
- Coat the sealing surfaces of the crankshaft damper with clean engine oil.
- Coat the crankshaft damper keyway with silicone gasket and sealant.
- Install the crankshaft damper.
Install the crankshaft bolt and the washer.
- Tighten to 145 Nm (107 lb-ft).
Install the crankshaft pulley and 4 bolts.
- Tighten to 63 Nm (46 lb-ft).
Install the drive belt. For additional information, refer to ACCESSORY DRIVE article.
Install the fan blade and the fan shroud. For additional information, refer to ENGINE COOLING article.
Install the air cleaner outlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.