LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 873 (Engine - 2.3L) >> Installation >> Engine >> Vehicles with manual transmission

Vehicles with manual transmission

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Attach the wiring harness retainers and connect the transmission electrical connectors.
    Fig 1: Locating Wiring Harness Retainers & Connecting Transmission Electrical Connectors
    GF0009013Courtesy of FORD MOTOR CO.
  2. Route the wiring harness over the transmission, position the bracket and install the nut. Connect the catalyst monitor sensor electrical connector.
    Fig 2: Locating Catalyst Monitor Sensor Electrical Connector & Nut
    GF0009012Courtesy of FORD MOTOR CO.
    • Tighten to 10 Nm (89 lb-in).
  3. Connect the HO2S electrical connector.
    Fig 3: Locating HO2S Electrical Connector
    GF0009011Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals