Vehicles with automatic transmission

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Install the 4 torque converter nuts.

Fig 1: Locating Torque Converter Nut
Courtesy of FORD MOTOR CO.
- Tighten to 35 Nm (26 lb-ft).
Install the transmission fluid indicator and tube assembly.

Fig 2: Locating Transmission Fluid Indicator & Tube Assembly
Courtesy of FORD MOTOR CO.

Attach the wiring harness retainers.

Fig 1: Locating Wiring Harness Retainers
Courtesy of FORD MOTOR CO.
Attach the wiring harness retainers and connect the transmission electrical connectors.

Fig 2: Locating Transmission Electrical Connectors
Courtesy of FORD MOTOR CO.
Route the wiring harness over the transmission, position the bracket and install the nut. Connect the catalyst monitor sensor electrical connector.

Fig 3: Locating Nut & Catalyst Monitor Sensor Electrical Connector
Courtesy of FORD MOTOR CO.
- Tighten to 10 Nm (89 lb-in).
Connect the heated oxygen sensor (HO2S) electrical connector.

Fig 4: Locating Heated Oxygen Sensor (HO2S) Electrical Connector
Courtesy of FORD MOTOR CO.

Install the transmission cooling tubes retaining bracket and the bolt.

Fig 1: Locating Transmission Cooling Tubes Retaining Bracket Bolts
Courtesy of FORD MOTOR CO.
- Tighten to 28 Nm (21 lb-ft).